====== KS-PTCL 信号通道修改 =======

KS-PTCL红外切光器系统的切光器和主机之间采用的是无线通讯的模式，当需要同时运行多套计时系统，互相距离较近可能会产生干扰，或者系统被第三方无线设备影响，信号不稳定时，会需要手动修改设备的无线信道。

==== 通讯主机信道修改 ====

确保通讯主机与电脑已用usb线相互连接。左下角指示图上鼠标右键，选择主机设置

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_1.png?600}}

选择通信频段，并点击修改

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_2.png?600}}

==== 切光器信道修改 ====

使用切光器专用6pin连接线连接电脑，同时确保通讯主机已连接电脑

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_3.png?600}}

点击切光器设置

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_4.png?600}}

若未连接，则会“显示没有可用端口”

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_5.png?600}}

若已连接，则会显示端口。并点击“连接”按钮，修改通信频段和设备类型，最后点击修改设置

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_6.png?600}}

设置完成，点击“断开”按钮

{{sports:equestrian:ks_ptcl_host_setup:ks_ptcl_host_setup_7.png?600}}